Leah's Glass Creations
Instructions
Instructions
DIRECTIONS FOR USE OF THE ADHESIVE:
TIPS:
- a clean surface will make for the best connections with the adhesive dot... remove all dust or dirt or oils on the surface
where attaching the Mobile
- if in need of more adhesive dots - they are a product made by 3M (Scotch Tape products) sold in most every store, look for
the red packages





I am personally as impatient as the best of us - and I have tried hanging it all at once, and the sticky dot just doesn't get
the chance to get as strong as its truly capable of - but if you follow the directions the little Mobi will not fall off until you
are ready to remove it.  
1. Peel paper backing off one side of the adhesive dot and apply dot to backside of the BLACK glass dot (hold for 30seconds)
2. Peel the second paper backing off the adhesive dot and firmly apply the glass dot to where you would like it to be hung
(the wire should extend upwards out of the black glass dot, so that the Mobi can be hung off its hook)
3. WAIT 2 HOURS BEFORE ATTACHING THE MOBI
ENJOY!!
AND when you are ready to remove it: grab the little foam tab that extends out of the adhesive and strech this little foam tab long, pulling away from the black dot
while holding the black dot in place, and when the foam tab is fully streched it will release from where-ever you have hung the Mobi without leaving any mark (so
it will not destroy your walls or leave a mess on your computer!)
There is one glass dot in the package which is BLACK and it is not yet attached to the rest of the Mobi - this is the piece that the Mobi will hang off of once it is stuck to something.  
Please follow these directions and let the adhesive set up for at least an hour before actually hanging the Mobi from the wire that comes out of the black glass dot...